- Product Description
- Connection Diagram
- The unique POWER+ technology, and other products in the same conditions, with the largest and most real-world headroom optimization for loudspeaker system;
- Power level and entertainment, performance is the most commonly used in the industry to match the speaker;
- Through the integration of a single modular design, the power supply and amplifier circuit integration into a piece of board, and with the new design of the area,The short path, the short air path and the wave type heat radiator structure can avoid the fault caused by the connection line between lines,The heat radiation efficiency of the whole machine is improved, the weight of the whole machine is reduced, the volume of the product is reduced, and the lower product is realized for transportation and installation.
- The full range of products are designed with the transistor directly attached to the radiator, can more effectively reduce the temperature of the power tube, improve the stability of the product.
- XLR input and link Connectors are used.
- Output using the Speakon NL4 and the binding posts .
- Dual input and parallel modes.
- Wind cooling system from front to rear.
- The ACL clipping protection and indication circuit are used to ensure the maximum dynamic range of the signal,DC protection, over temperature protection, infrasonic protection, and ensure the stability of products and effects.
Output Power(1KHz THD＜1%)
8Ω Dual channel driver
4Ω Dual channel driver
8Ω channel bridge driver
＜0.08%（-3dB Power 8Ω/1kHz）
Boot soft start
Over temperature protection
Required AC Mains
AC 220V 50/60Hz
Rear panel interface
Input mode switch
Output Mode Switch
AC Mains Connection
IEC-type AC mains inlet
Power Indicator-ACT/Clip(peak) Indicator-ACL/
Signal Indicator-SIG/ -6dB/-3dB
21 Step gain conntroller
AC conntrol switch
Front to back air blow
483x335x88mm/The chassis is wide inside 440mm
Get in touch with us